Kia Sorento: Components
| 2WD |
| 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm |
5. Rear shock absorber 6. Rear cross member 7. Trailing arm |
| 4WD |
| 1. Rear assist arm 2. Rear cross member 3. Rear drive shaft 4. Rear upper arm |
5. Rear coil spring 6. Rear stabilizer bar 7. Rear shock absorber 8. Rear lower arm |
Rear Shock Absorber Removel
2WD
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 ...
See also:
Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine will probably be too hot. If this happens,
you should:
1.Pull off the r ...
Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
...
Rearview camera (If equipped)
The rearview camera will activate with the ignition switch ON and the shift lever
in the R (Reverse) position.
This system is a supplemental system that shows behind the vehicle through the
rearv ...
Copyright В© www.ksmanual.com 2014-2024