1. |
Remove the rear wheel and tire (A) from rear hub.
|
2. |
Loosen the drain plug (A) and pull out the differential gear oil.
|
3. |
Remove the rear driveshaft.
(Refer to Rear Driveshaft Assembly - "Rear DriveShaft")
|
4. |
Remove the propeller shaft.
(Refer to Propeller Shaft Assembly - "Propeller Shaft")
|
5. |
Remove cover (B) as loosen screw (A-4ea).
|
6. |
Disconnect the pressure sensor connector (A) and oil hydraulic
motor connector (B).
|
7. |
Remove rear differential assembly (B) as loosen mounting (A-4ea)
after install jack.
|
8. |
After loosen the bolt and then remove the differential carrier
(B) from the coupling (A).
|
9. |
Install in the reverse order of removal.
|
10. |
Gear oil is injected.
|
11. |
Check the wheel alignment.
(Refer to Suspension System - "Alignment")
|
Oil hydraulic Motor(Actuator) Installation
1.
Before installation, wipe the surface with a clean cloth.
2.
Check the O-rings (A) of the new hydraulic motor (actuators).
...
Direct Electro Hydraulic Actuator Coupling Removal
Coupling Maintenance Precautions
Maintain the coupling at a horizontal level.
•
...
General Service Information
Protection Of The VehicleAlways be sure to cover fenders, seats, and floor areas
before starting work.
The support rod must be ...