Kia Optima Manuals

Kia Sorento: Propeller Shaft Removal and Installation - Propeller Shaft Assembly - Driveshaft and axle - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Propeller Shaft Removal and Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Propeller Shaft Assembly / Propeller Shaft Removal and Installation

1.
After making a match mark on the flange yoke and transfer companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

3.
After making a match mark on the flange yoke and 4WD coupling companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
  
Do not reuse bolts.

4.
Install in the reverse order of removal.
  
•
When assembl ying propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.
Propeller Shaft Components
1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Differential Carrier Assembly
...

See also:

Circuit Diagram
...

Front Driveshaft Components
1. Front driveshaft (LH) 2. Inner shaft bearing bracket 3. Front driveshaft (RH) [LH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ bo ...

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Categories


Copyright В© www.ksmanual.com 2014-2024