Kia Sorento: Rear Driveshaft Reassembly
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Rear Driveshaft Assembly / Rear Driveshaft Reassembly
| 1. |
Wrap tape around the driveshaft splines (TJ side ) to prevent
damage to the boots.
|
| 2. |
Apply grease to the driveshaft and install the boots.
|
| 3. |
Apply the specified grease to the inner race (A) and cage (B).
Install the cage (B) so that it is offset on the race as shown.
|
| 4. |
Apply the specified grease to the cage and fit the balls into
the cage.
|
| 5. |
Position the chamfered side (A) as shown in the illustration.
Install the inner race on the driveshaft(B), and then the snap ring.
|
| 6. |
Apply the specified grease to the outer race and install the BJ
outer race onto the driveshaft.
|
| 7. |
Apply the specified grease into the TJ boot and install the boot
with a clip.
|
| 8. |
Tighten the TJ boot bands.
|
| 9. |
Add the specified grease to the BJ as much as wiped away at inspection.
|
| 10. |
Install the boots.
|
| 11. |
Tighten the BJ boot bands.
|
| 12. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
Rear Driveshaft Disassembly
•
Do not disassemble the BJ assembly.
•
...
See also:
Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature
and interrupt compressor relay power in order to prevent evaporator from freezing
by excessive cooling
...
Rear Wheel Speed Sensor Removal
4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Rear Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...
Copyright © www.ksmanual.com 2014-2024