Kia Sorento: Rear Driveshaft Disassembly
•
|
Do not disassemble the BJ assembly.
|
•
|
Special grease must be applied to the driveshaft joint.
Do not substitute with another type of grease.
|
•
|
The boot band should be replaced with a new one.
|
|
1. |
Remove the TJ boot bands and pull the TJ boot from the TJ outer
race.
(1) |
Using a pliers or flat-tipped (-) screwdriver, remove
the LH boot band and LH TJ boot band from the driveshaft.
|
(2) |
Remove RH boot band and RH TJ boot band in the same way
of LH removal procedure.
Be careful not to damage the boot.
|
|
|
2. |
Pull out the driveshaft from the TJ outer race.
|
3. |
Remove the snap ring (A) and take out the inner race(B), cage(C)
and balls(D) as an assembly.
|
4. |
Clean the inner race, cage and balls without disassembling.
|
5. |
Remove the BJ boot bands and pull out the TJ boot and BJ boot.
If the boot (A) is to be reused, wrap tape(B) around the
driveshaft splines(C) to protect the boot (A).
|
|
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the ball joint for wear and damage.
3.
Che ...
1.
Wrap tape around the driveshaft splines (TJ side ) to prevent
damage to the boots.
2.
Apply grease to the driveshaft and install the boo ...
See also:
Circuit Diagram
...
Heater & A/C Control Unit (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...
Child restraint system
Children riding in the vehicle should sit in the rear seat and must always be
properly restrained to minimize the risk of injury in an accident, sudden stop or
sudden maneuver.
According to acciden ...