1. |
Remove the rear wheel and tire (A) from rear hub.
|
2. |
Remove the coking nut (A).
|
3. |
Remove the rear shock absorber.
(Refer to Suspension System - "Rear Shock Absorber")
|
4. |
Remove the parking brake cable.
(Refer to Brake System - "Parking Brake Cable")
|
5. |
Remove the rear upper arm (A) after loosen the bolt (B).
|
6. |
Remove the rear lower arm (B), spring (C) as loosening bolt (A)
after supporting rear lower arm (B) with jack.
|
7. |
Remove the rear assist arm (C), trailing arm (D) as loosening
bolt (A), nut (B).
|
8. |
Separate the end (B) of rear driveshaft on rear axle assembly
(A).
|
9. |
Insert a pry bar (A) between the differential case (B) and joint
case (C), and separate the driveshaft (D) from the differential case.
|
10. |
Install in the reverse order of removal.
|
11. |
Check the wheel alignment.
(Refer to Suspension System - "Alignment")
|
Brake Booster Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Signal Waveform
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line.
(Refe ...