1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and retainer ring (B) on the driveshaft
splines (C).
|
3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
4. |
Install the both boot band.
|
5. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
System Overview
RPAS (Rear Parking Assist System) is an electronic driving aid that warns
the driver to be cautious while parking or in low speed environments. The sensor
uses ultrasonic waves to detect obje ...
Auto Head lamp leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Height sensor signal change
...
Curtain Airbag (CAB) Module Description
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain airbag by us ...