Kia Sorento: TJ Joint Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Inspection
| 1. |
Check the spider assembly for roller rotation, wear or corrosion.
|
| 2. |
Check the groove inside the joint case for wear or corrosion
|
| 3. |
Check the TJ boots for damage and deterioration.
|
TJ Joint Removal
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
See also:
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
Operation
Power Tailgate Opening
** - Primary switch signal received by PTGM via CAN bus (sent by IPM)
PTGM Opening procedure:
1.
Opening can be triggered after a signal i ...
Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant
passage of the cylinder head for detecting the engine coolant temperature. The
ECTS uses a thermistor that changes re ...
Copyright В© www.ksmanual.com 2014-2024