Kia Sorento: TJ Joint Components
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Components
| [LH] |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly |
9. Retainer ring 10. TJ housing 11. Housing circlip |
| [RH] |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing |
13. Housing circlip |
Front Driveshaft Removal and Installation
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
TJ Joint Removal
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
See also:
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Rear Oil Seal Installation
1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09 ...
Transaxle Oil Temperature Sensor Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Copyright В© www.ksmanual.com 2014-2024