1. |
Remove the front wheel and tire (A) from front hub .
|
2. |
Remove the brake caliper mounting bolts, and then place the brake
caliper assembly (B) with wire.
|
3. |
Remove the coking nut (A).
|
4. |
Remove the brake hose (A) and wheel speed sensor (B).
|
5. |
Remove the tie rod end ball joint (C) from the knuckle.
|
6. |
Disconnect the ball joint(A) from knuckle using the special tool
(09568-4A000).
|
7. |
Remove the lower arm (A) mounting bolt and nut from the knuckle.
|
8. |
Using a plastic hammer (A), disconnect driveshaft (C) from the
axle hub (B).
|
9. |
Remove the RH side cover (A).
|
10. |
Remove the mounting bolts (A,B) of Upper roll rod bracket (C).
|
11. |
Loosen the inner shaft mounting bolts and then disconnect the
inner shaft (A).
|
12. |
Insert a pry bar (A) between the transaxle case and joint case,
and separate the drive shaft (B) from the transaxle case.
|
13. |
Install in the reverse order of removal.
|
Transaxle Oil Temperature Sensor Circuit Diagram
...
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspec ...
Keep your vehicle clean
The best way to prevent corrosion is to keep your vehicle clean and free of corrosive
materials. Attention to the underside of the vehicle is particularly important.
If you live in a high-corrosi ...