Kia Optima Manuals

Kia Sorento: Oil hydraulic Motor(Actuator) Removal - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Oil hydraulic Motor(Actuator) Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Oil hydraulic Motor(Actuator) Removal

1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling")
2.
Keep going perpendicular state after remove the coupling assembly.
  
While removing the hydraulic motor from the coulping assembly, make sure that the hydraulic motor keeps being vertical to the level of work table or ground as shown in the image below not to allow the coupling oil to spill out. If the coupling oil spilled out of the hydraulic motor or the coupling assembly, replace the coupling assembly with new one. (We do not recommend to add or change the coupling oil because the coupling oil's spec and fill ratio greatly effect the performance and durability of the coupling assembly.)

3.
Remove the hydraulic motor (A) after loosening bolts with hex wrench.
  
•
Remove the hydraulic motor (actuators) after dropping residual oil as much as possible inside the coupling. (about 5~10 sec)

Oil hydraulic Motor(Actuator) Inspection
   If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according t ...

Oil hydraulic Motor(Actuator) Installation
1. Before installation, wipe the surface with a clean cloth. 2. Check the O-rings (A) of the new hydraulic motor (actuators). ...

See also:

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST/ : For a single wiping cycle, move the lever to this (MIST/ ) position andrelease it. The wipers will operate continuously if the l ...

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Timing Chain Inspection
Sprockets, Hydraulic Tensioner, Chain Guide, Tensioner Arm, Timing Chain 1. Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Replace ...

Categories


Copyright В© www.ksmanual.com 2014-2024