Kia Sorento: Direct Electro Hydraulic Actuator Coupling Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Direct Electro Hydraulic Actuator Coupling Removal
Coupling Maintenance Precautions
Maintain the coupling at a horizontal level.
|
| 1. |
Remove the 4WD coupling assembly bolts (A-3ea) mounted to the
rear propeller shaft (B).
|
| 2. |
Using a flat tool, separate the propellar shaft from 4WD coupling
assembly.
|
| 3. |
Disconnect the pressure sensor connector (A) and Oil hydraulic
Motor connector (B).
|
| 4. |
Loosen the coupling assembly mounting bolts (A-4ea).
|
| 5. |
Using a flat tool, separate the 4WD coupling assembly from the
rear differential carrier assembly.
|
Direct Electro Hydraulic Actuator Coupling Inspection
All units are filled up with coupling fluid (ultra-low viscosity
ATF) prior to shipping. Inspection, fill-up, and replac ...
Direct Electro Hydraulic Actuator Coupling Installation
1.
Install in the reverse order of removal.
•
...
See also:
Oil Cooler Installation
1.
Apply a light coat of engine oil to the oil cooler packing surface (A),
and then install the oil cooler with fix bolt (B).
Tightening torque:
...
Specifications
Items
Specifications
Rated voltage
5V
Load
Max. 1mA
Detection illuminations
Tail lamp
ON : 2.7 ± 0.05 (V)
OFF : 4.3 ...
Battery Cleaning
1.
Make sure the ignition switch and all accessories are in the OFF
position.
2.
Disconnect the battery cables (negative first).
...
Copyright © www.ksmanual.com 2014-2024