1. |
Install in the reverse order of removal.
|
2. |
Prior to installing a new ECU, upload the original ECU’s clutch
learing to the replacement ECU using the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
|
Antenna Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable. ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly
may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearanc ...