Kia Optima Manuals

Kia Sorento: Front Wheel Transfer Assembly Installation - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Front Wheel Transfer Assembly Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Front Wheel Transfer Assembly Installation

1.
Install in the reverse order of removal.
  
1.
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2.
Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA or equivalent

3.
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.
Front Wheel Transfer Assembly Removal
   It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is requ ...

Oil Seal Replacement
[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Re ...

See also:

IMS Power Seat Control Circuit Diagram
...

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedu ...

Propeller Shaft Components
1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Categories


Copyright В© www.ksmanual.com 2014-2024