Kia Sorento: Transfer Fluid Inspection - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Transfer Fluid Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Transfer Fluid Inspection

  
•
Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year.
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the oil filler plug (A).
[Gasoline 2.4]

[Gasoline 3.3]

3.
Check the oil level.
  
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the oil filler plug with new gasket.

Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

5.
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Transfer Assembly
...

Transfer Fluid Replacement
   Change Normal Use Severe Use No service required ...

See also:

Component Location
1. Fuel filler door open switch 2. Fuel filler door release actuator ...

Schematic Diagrams
MDPS Circuit Diagram Harness Connector Connector Pin no Pin name Battery 1 Battery + 2 Battery - Vehicl ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...

Copyright В© www.ksmanual.com 2014-2024