Kia Sorento: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
See also:
Relay Box (Passenger Compartment) Component Location
...
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring Spec.)
1
GND
DC Ground
TMU
Battery
...
Copyright В© www.ksmanual.com 2014-2024