1. |
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
|
2. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
3. |
Drain the coolant.
(Refer to Engine Mechanical System - "Coolant")
|
4. |
Remove the drain plug (A) and reinstall the drain plug after draining
ATF totally.
|
5. |
Remove the wiring bracket installation bolt (A).
|
6. |
Remove the ATF Injection hole(eyebolt) (A).
|
7. |
Disconnect the coolant hose (B) after removing the coolant hose
clamp (A).
|
8. |
Disconnect the hose (B) after removing the automatic transaxle
fluid cooler hose clamp (A).
|
9. |
Remove the valve body cover (A).
|
10. |
Disconnect the oil temperature sensor connector (A).
|
11. |
Remove the oil temperature sensor (A) after removing a bolt.
|
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
...
Voice Command List
Common Commands:
These commands can be used in most operations. (However a few commands may not
be available during certain operations)
FM/AM radio commands:
Commands available during FM, ...
Front Driveshaft Components
1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)
[LH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ bo ...