When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the TCM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the TCM learns the smart key information
automatically.
|
1. |
Install in the reverse order of removal.
|
1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side check
point. If the problem is found, repair it.
|
2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it.
|
3. |
If problem is not found in Step 1 and 2, the TCM could be faulty.
If so, make sure there were no DTC's before swapping the TCM with a
new one, and then check the vehicle again. If DTC's were found, examine
this first before swapping TCM.
|
4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be broken)
into a known-good vehicle and check the vehicle. If the problem occurs
again, replace the original TCM with a new one. If problem does not
occur, this is intermittent problem (Refer to “Intermittent Problem
Inspection Procedure” in Basic Inspection Procedure).
|
Audio Head Unit
(1)
(EJECT)
Ejects the disc.
(2)
Changes to FM/AM/SIRIUS mode.
Each time the key is pressed, the mode is changed in order of FM1 ➟ FM2 ➟ AM
➟ SAT1 ➟ SAT2 ...
Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure
and DTC guide. ...
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor
2. Rear wheel speed sensor cable
...