When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the TCM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used TCM]
[In the case of installing new TCM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the TCM learns the smart key information
automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the TCM Connector (A).
|
3. |
Remove the battery.
(Refer to Engine Electrical System - "Battery")
|
4. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
5. |
Remove the mounting bolts (A) and nut (B), and then remove the
TCM (C).
|
6. |
After removing the installation nuts (A) and screws (B), remove
the TCM (C) from the bracket.
|
Sound settings
Press the
key
Select [Sound] through
TUNE knob or key
Select menu through
TUNE knob
Sound Settings
This menu allows you to set the ‘Bass, Middle, Treble’ and the Sound Fader ...
Flex Steering Inspection
1.
Check the audio flex streeing switch (A) for resistance between
terminals in each switch position.
Switch
Resistance (±5%)
...
Panorama Sunroof Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between
the front (A) and rear (B) glass and if needed adjust it.
...