Kia Sorento: Installation
1. |
Install in the reverse order of removal.
If the oil seal on the transaxle case side is damaged
and fluid is leaking, replace the oil seal with a new unit.
When installing the new oil seal, use the specialized
tool.
2WD both side:
09453-3L240
4WD transaxle case side:
09453-3L240
4WD transaxle housing
side : 09453-2W100
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
• |
Adding automatic transaxle fluid.
(Refer to Hydraulic System - "Fluid")
|
• |
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
|
• |
After replacing the automatic transaxle, clear
the Diagnostic Trouble Code(DTC) using the GDS tool.
DTC cannot be cleared by disconnecting the battery.
|
• |
When replacing the automatic transaxle, reset
the automatic transaxle's values by using the GDS.
|
• |
Perform TCM learning after replacing the transaxle
to prevent slow transaxle response, jerky acceleration
and jerky startup.
(Refer to Automatic Transaxle Control System -
"Repair procedures")
|
|
|
1.
Remove the engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Remove the air cleaner assembly and air du ...
See also:
Record your key number
The key code number is stamped on the bar code tag attached
to the key set. Should you lose your keys,
this number will enable an authorized Kia dealer to duplicate the keys easily.
Remove the ba ...
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ ...
Compressor Inspection
1.
Check the plated parts of the disc & hub assembly (A) for color
changes, peeling or other damage. If there is damage, replace the clutch
set.
...