Kia Sorento: Fuel Pump Removal
| 1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
| 2. |
Remove the rear seat.
(Refer to Body - “Rear Seat Assembly”)
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure
sensor connector (B).
|
| 5. |
Disconnect the fuel feed tube quick connector (C) and the vapor
tube quick-connector (D).
|
| 6. |
Remove locking ring (A) by using the special service tool.
|
| 7. |
Disconnector the vapor tube quck-connector (A) at the fuel pump,
and then remove the fuel pump from the fuel tank.
|
Fuel Pump Inspection
[Fuel pump motor]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
...
Fuel Pump Installation
1.
Install in the reverse order of removal.
Be careful of fuel pump direc ...
See also:
Compressor Disassembly
1.
Remove the engine room under cover by loosening the mounting clip
(A) and bolts (B).
2.
Separate the front portion of the front ...
IMS module Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat")
...
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Copyright © www.ksmanual.com 2014-2024