1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
2. |
Remove the rear seat assembly.
(Refer to Body - “Rear Seat Assembly")
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure
sensor connector (B).
|
5. |
Disconnect the fuel feed tube quick connector (C).
|
6. |
Remove the rear - LH wheel & tire.
|
7. |
Lift the vehicle and support the fuel tank with a jack.
|
8. |
Remove the center & rear muffler assembly.
(Refer to Engine Mechanical System - “Muffler”) [4 WD]
|
9. |
Remove the propeller shaft.
(Refer to Driveshaft and axle - “Propeller Shaft”) [4WD]
|
10. |
Disconnect the fuel filler hose (A) and the ventilation tube quick-connector
(B).
|
11. |
Disconnect the ventilation tube quick-connector (A).
|
12. |
Disconnect the vapor tube quick-connector (B).
|
13. |
Remove the fuel tank (B) from the vehicle after removing the fuel
tank band (A).
|
Oil hydraulic Motor(Actuator) Circuit Diagram
...
Exhaust Manifold Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Disconnect the front oxygen sensor ...
Battery Sensor Description
Vehicles have many control units that use more electricity. These units
control their own system based on information from diverse sensors. It is important
to have a stable power supply as th ...