Kia Sorento: Components Location
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Components Location
| 1. Fuel tank 2. Fuel pump 3. Fuel filter 4. Fuel pressure regulator 5. Canister 6. Fuel tank air filter 7. Fuel tank band |
8. Fuel tank pressure sensor (FTPS) 9. Canister close valve (CCV) 10. Fuel level sender (FLS) 11. Fuel filler hose 12. Ventilation tube 13. Vapor tube 14. Fuel pump locking ring |
| [High Pressure Fuel Line] |
| 1. High Pressure Fuel Pump 2. High Pressure Fuel Pipe |
3. Delivery Pipe 4. Injector |
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. So don’t do any repair work right
after engine stops.
|
Fuel Pressure Test (Low pressure system)
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...
See also:
Replacement
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Front Wheel Transfer Assembly Components Location
1. Under cover
2. Transaxle Assembly
3. Transfer assembly
4. Propeller shaft
5. Coupling assembly
1. Under cover
2. Transaxle Assembly
3 ...
Blind Spot Detection Switch Installation
1.
Install the crash pad side switch assembly after connecting the
connector.
2.
Install the crash pad lower panel.
...
Copyright В© www.ksmanual.com 2014-2024