1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the variable intake solenoid valve connector (A).
|
3. |
Disconnect the vacuum hoses (B,C) from the valve.
|
4. |
Remove the installation bolt (D), and then remove the valve from
the surge tank.
|
Components Location
1. PCV Valve
2. Canister
3. Purge Control Solenoid Valve (PCSV)
4. Fuel Tank Pressure Sensor (FTPS)
5. Canister Close Valve (CCV)
6. Fuel Level Sender (FLS)
7. Fuel Ta ...
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
R ...
Engine coolant
The high-pressure cooling system has a reservoir filled with year round antifreeze
coolant. The reservoir is filled at the factory.
Check the antifreeze protection and coolant level at least once a ...