1. |
Remove the combustion seal (A) with a wire cutter.
|
2. |
Before the assembly of the sealing ring the groove must be cleaned
using a clean cloth.
Any coking of the injector sealing surface must be carefully removed
with a brass-wire brush.
|
3. |
Place the seal installing guide (B) (SST No.: 09353-2B000) on
the tip of the injector not to damage the injector tip (A).
Push the sealing ring (C) with thumb and index finger over the
conical assembly tool until it snaps into the groove.
The complete assembly must not take longer than 2 to 3 seconds.
|
4. |
To size the sealing ring the injector is first introduced into
the sizing tool (A) (SST No.: 09353-2B000) and then pressed and at the
same time rotated 180В° into the sizing tool.
|
5. |
Pull the injector out of the sizing tool by turning it in the
reverse direction to that used for the press-in process.
|
6. |
Check the combustion seal (A) installation.
|
Engine Room Under Cover Removal and Installation
1.
Unfasten the fasteners and bolts and then remove the engine room under
cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf ...
Shift Cable Installation
1.
Install in the reverse order of removal.
Set shift lever and inhibitor ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...