Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (C), the bolt (B) and then remove
the accelerator pedal module.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18 ...
See also:
Engine compartment
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake/clutch fluid reservoir
4. Air cleaner
5. Fuse box
6. Negative battery terminal
7. Positive battery terminal
8. Radiator cap
9. E ...
Oil Seal Replacement
[Right side]
1.
Remove the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
2.
Re ...
Relay Box (Engine Compartment) Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Pull out the relay from the engine compartment relay box.
Power Relay (Type A)
...
Copyright В© www.ksmanual.com 2014-2024