Kia Sorento: Installation

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refe ...

Accelerator Position Sensor (APS)

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

See also:

Front Wiper Motor Removal
1. Remove the windshield wiper arm and blade after removing a nut (B) and wiper cap (A). 2. Remove the windshield wiper arm and bla ...

PTG Spindle Installation
1. Connect the PTG spindle, bracket and connector. Tightening torque : 6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft) ...

Power Mosfet (DATC) Inspection
1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be rep ...