Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
| 3. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
|
| 4. |
Disconnect the rail pressure sensor connector (A), and then remove
the sensor (B) from the delivery pipe.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Battery Removal
1.
Disconnect the battery (-) terminal and (+) terminal (A).
2.
Remove the battery mounting bracket (B) and the insulation pad
and then rem ...
Troubleshooting
1.
No windows operate from the main switch on the driver's door.
2.
Driver's side window does not operate.
...
Copyright © www.ksmanual.com 2014-2024