Kia Optima Manuals

Kia Sorento: Removal - Heated Oxygen Sensor (HO2S) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
  
Note that the SST (Part No.: 09392-2H100 or 09392-1Y100) is useful when removing the heated oxygen sensor.
[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]
Inspection
1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S termi ...

Installation
   • Install the component with the specified torques. • ...

See also:

Circuit Diagram
...

Hazard Lamp Switch Installation
1. Install the heater control unit to the center fascia panel. 2. Install the center fascia panel. ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Categories


Copyright © www.ksmanual.com 2014-2024