Kia Sorento: Knock Sensor (KS)

Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.

When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element. When a knock occurs, the sensor produces voltage signal. The ECM retards the ignition timing when knocking occurs. If the knocking disappears after retarding the ignition timing, the ECM will advance the ignition timing. This sequential control can improve engine power, torque and fuel economy.

Installation

   • Install the component with the specified torques. • ...

Specification

Item Specification Capacitance (pF) 850 ~ 1,150 ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the sensor ...

Oil hydraulic Motor(Actuator) Circuit Diagram
...

Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the proced ...