|
[Bank 1 / Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the camshaft position sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor.
|
[Bank 1 / Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the camshaft position sensor connector (A).
|
3. |
Remove the hanger and the protector.
|
4. |
Remove the installation bolt (B), and then remove the sensor.
|
Antenna Removal
1.
Remove the rear roof trim.
(Refer to Body - "Roof trim")
2.
Disconnect the power cable (A).
3. ...
Oil Pan Removal
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ve ...
Master Cylinder Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder
...