1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the crankshaft position sensor connector (A).
|
3. |
Remove the protector (A).
|
4. |
Remove the installation bolt (A), and then remove the crankshaft
position sensor.
|
Fuel Line Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the F ...
Component Location
1. IPM (Intelligent intergrated Platfrom Moduel)
2. Ultrasonic sensor
...
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...