1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the engine coolant temperature sensor connector (A).
|
3. |
Remove the spring clip (A), and then pull the sensor from the
water temperature control assembly.
|
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ ...