Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
2.
Che ...
Copyright © www.ksmanual.com 2014-2024