1. |
Check DTC(s) and clear if exist.
|
2. |
Select "Data Treatment", to reset the ETC adaptive value.
|
3. |
Select "Resetting adaptive values".
|
4. |
Select "Reset", then wait 10 seconds after turning ignition key
off (Relay OFF).
|
5. |
Wait for 5 seconds after turning the ignition ON (ETC adaptive
value relearn).
If equipped with Button Engine Start System, push the engine start/stop
button 2 times without depressing the brake pedal. This will allow the
ECM to automatically learn the throttle valve position; then wait for
approximately 5 seconds.
|
6. |
Start engine.
|
7. |
Recheck DTC(s).
|
Drive Belt Removal and Installation
1.
For release the tension, turn the drive belt tensioner counterclockwise
then remove the drive belt (A).
2.
Install the drive be ...
Seat Heater Component Location
...
Rear Door Components
1. Door inside handle cap
2. Door trim
3. Door belt inner weatherstrip
4. Door module
5. Door panel
6. Door belt weatherstrip
7. Door body side weatherstrip
8. Door ...