Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (B).
|
| 5. |
Remove the installation bolts (C), and then remove the ETC module
from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Specifications
Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-22 ~ +176°F (-30°C ~ +80°C)
Rated load
Dimmer & ...
ICM Relay Box Inspection
Rear Wiper Motor relay
Check for continuity between the terminals.
1.
There should be continuity between the No.1 and No.3 terminals
when power and ground are conne ...
Engine Room Under Cover Components
1. Under Cover
2. Side Cover (RH)
3. Side Cover (LH)
...
Copyright © www.ksmanual.com 2014-2024