1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
3. |
Turn the ignition switch OFF and disconnect the scantool from
the DLC.
|
4. |
Disconnect the ETC module connector and measure the resistance
between the ETC module terminals 1 and 2.
|
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the ETC module connector.
|
3. |
Measure resistance between the ETC module terminals 3 and 6.
|
4. |
Check that the resistance is within the specification.
|
System settings
Press the
key
Select [System]
Select menu through
TUNE knob
Memory Information
Displays currently used memory and total system memory.
Select [Memory Information]
OK The currently us ...
Component Location
1. Windshield wiper arm & blade
2. Wiper & washer switch
3. Windshield washer hose
4. Windshield wiper motor & linkage
5. Washer motor
6. Washer reservoir
...
Panorama Sunroof Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Open the sunglass case cover from the overhead console then remove
the 2 screws holding ...