Kia Sorento: Engine Control Module (ECM) Adjustment - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Engine Control Module (ECM) Adjustment

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Adjustment

•
After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
1)
[If installing a used ECM]
1.
Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - Repair procedures")
2.
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - Repair procedures")
2)
[If installing a new ECM]
Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "Immobilizer System - Repair procedures")
•
After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
1)
[If installing a used ECM]
1.
Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "Smart key System - Repair procedures")
2.
After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
2)
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
•
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned.
(Refer to "Engine Control System - ETC - adjustment")
ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

ETC (Electronic Throttle Control) System
...

See also:

Inspection
1. Turn ignition switch OFF. 2. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") ...

Special Tools
Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly ...

AUX(Auxiliary) Jack Removal
   Put on gloves to protect your hands.    ...

Copyright © www.ksmanual.com 2014-2024