Kia Sorento: Engine Control Module (ECM) Installation

Engine Control Module (ECM) Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ECM Connector (A). ...

ECM Problem Inspection Procedure

1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

See also:

Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling [Inactive] [Active] Operation Order 1. 4WD ECU receives CAN signals from the vehicle's sensors. ...

Fluid Service Adjustment Procedure
Oil level Check    A check of ATF level is not normally required during scheduled services. If an oil leak is ...

Rear Cross Member
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...