1. |
Disconnect the cruise control switch connector from the control
switch.
|
2. |
Measure resistance between terminals on the control switch when
each function switch is ON (switch is depressed).
|
3. |
If not within specification, replace switch.
|
1. |
Connect the cruise control switch connector to the control switch.
|
2. |
Measure voltage between terminals on the harness side connector
when each function switch is ON (switch is depressed).
|
3. |
If not within specification, replace switch.38
|
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the overhead console (A).
...
Antenna Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable. ...
Canister Installation
1.
Install in the reverse order of removal.
...