1. |
Disconnect the battery negative terminal.
|
2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
3. |
Remove the ETC module.
(Refer to Fuel System - "ETC")
|
4. |
Remove the intake manifold stay (A).
|
5. |
Disconnect the starter cable (A) from the B terminal on the solenoid,
then disconnect the connector (B) from the S terminal.
|
6. |
Remove the 2 bolts (C) holding the starter, then remove the starter.
|
7. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Troubleshooting, Customer Complaint Analysis Check Sheet
There are six areas where a problem can occur: wiring harness, the radio,
the CD player, and speaker. Troubleshooting enables you to confine the problem
to a particular area.
Chart 1 ...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Cruise Control Switch Installation
1.
Install in the reverse order of removal.
...