Kia Sorento: Starter Description

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

Troubleshooting

   • The battery must be in good condition and fully charged for this troubleshooting. ...

Starter Specification

Starter Item Specification Rated voltage 12 V, 1.2 kW The number of pinion teeth 11 Performance [No-load, 11 V] Ampere ...

See also:

Emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you ha ...

Output Speed Sensor Removal
1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body") 2. Disconnect the input & output speed senso ...

Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling [Inactive] [Active] Operation Order 1. 4WD ECU receives CAN signals from the vehicle's sensors. ...