Kia Sorento: Battery Sensor Installation
1. |
Install in the reverse order of removal.
Battery sensor cable installation
bolt:
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)
Battery (-) terminal l tightening
nut:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
• |
For the vehicle equipped with a battery sensor,
be careful not to damage the battery sensor when the
battery is replaced or recharged.
|
1. |
When replacing the battery, it should be same
one (type, capacity and brand) that is originally installed
on your vehicle. If a battery of a different type is
replaced, the battery sensor may recognize the battery
to be abnormal.
|
2. |
When installing the ground cable on the negative
post of battery, tighten the clamp with specified torque.
An excessive tightening torque can damage the PCB internal
circuit and the battery terminal .
|
3. |
When recharging the battery, ground the negative
terminal of the booster battery to the vehicle body.
|
|
|
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the bat ...
See also:
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Component Location
1. Seat Memory Unit (IMS)
2. IMS control switch
3. Outside mirror
4. IMS mirror control (Driver power window switch)
...
High Pressure Fuel Pump Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...