1. |
Disconnect the battery negative terminal.
|
2. |
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove the cable from alternator "B" terminal (C).
|
3. |
Remove the drive belt (A) after turning the drive belt tensioner
(B) counter clockwise.
|
4. |
Full out the through bolt and then remove the alternator (A).
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Circuit Diagram
...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition ...