Kia Sorento: Alternator Circuit Diagram
•
|
COM signal - When
controlling the voltage generated, the ECM sends the target
voltage data to the alternator via a PWM signal.(High voltage:
4V or higher, low voltage: 2V or lower)
|
•
|
FR signal - The
transistor activation signal inside the alternator monitors
the voltage generated by the alternator to control the excitation
current before it sends the FR signal to the ECM. (At certain
RPM/electric loads, the FR duty can remain static. However,
more often, the RPM, electric load, target voltage, etc. are
always changing in the vehicle, so the FR must also change constantly)
|
•
|
L signal - Turns
on the battery warning lamp on the dashboard when the battery
charging system malfunctions. (Conditions for turning on the
lamp - overcharge, over discharge, a field coil blown inside
the alternator)
|
•
|
B+ terminal - The
output voltage from the generator travels to the battery via
the B+ terminal.
|
|
1. Overrun Alternator Pully (OAP)
2. Front bracket
3. Front bearing
4. Rotor
5. Rear bearing
6. Rear bracket
7. Through bolt
8. Regulator assembly
9. Regulator b ...
1.
Disconnect the battery negative terminal.
2.
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove th ...
See also:
Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure
and DTC guide. ...
Compass Mirror Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly,
or you are driving in specific places (tunnel, parking lot in building, underground
parking lot, near transforme ...
Oil hydraulic Motor(Actuator) Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator
Coupling")
2.
Keep goin ...