[On vehicle inspection] |
1. |
Accelerate the engine to about 3,000 rpm 3 times or more.
|
2. |
Remove the spark plug.
|
3. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as
below.
|
[Component Inspection] |
1. |
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
|
2. |
Check the electrode. Measure the insulation resistance with an
ohmmeter.
If the resistance is less than the specified value, adjust the
electrode gap.
|
3. |
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
|
Front Hub / Knuckle / Tone Wheel Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
Circuit Diagram
...
Parking Assist Sensor Installation
1.
Install the rear ultra sensor after connecting the connector.
2.
Install the rear bumper cover.
3.
Connect t ...