1. |
Remove the engine cover.
|
2. |
Disconnect the battery negative terminal.
|
3. |
Disconnect the front oxygen sensor connector (A) and the rear oxygen
sensor connector (B).
|
4. |
Remove the front muffler.
(Refer to Intake And Exhaust System - "Muffler")
|
5. |
Remove the heated oxygen sensor (A).
(Refer to Engine Control/Fuel System - "Heated Oxygen Sensor (HO2S)")
|
6. |
Remove the exhaust manifold heat protector (B).
|
7. |
Remove the exhaust manifold stay (A).
|
8. |
Remove the exhaust manifold (A) with the gasket (B).
When installing the intake manifold, tighten the nuts with pre-torque
first, and then tighten the nuts with specified torque in the sequence
shown.
|
9. |
Install in the reverse order of removal.
|
Heater Unit Component Location
...
Special Service Tools
Tool(Number and Name)
Illustration
Use
09495-3K000
Band installer
Installation of ear type boot band
09568-4A000
Ball joint ...
Specification
Item
Specification
Coil Resistance (Ω)
19.9 ~ 22.9 [20°C(68°F)
...