1. |
Disconnect the battery negative terminal.
|
2. |
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
|
3. |
Disconnect the intake OCV (Oil control valve) connector (A).
|
4. |
Disconnect the VIS (Variable intake system) connector (A), the OPS (Oil
pressure switch) connector (B), the injector extension connector (C),
the knock sensor connector (D), the alternator connector (E) and the
air compressor connector (F).
|
5. |
Disconnect the ETC (Electronic throttle control) connector (A) and MAPS
(Manifold absolute pressure sensor) & IATS (Intake air temperature sensor)
connector (B).
|
6. |
Disconnect the PCV (Positive crankcase ventilation) hose (A).
|
7. |
Disconnect the vacuum hose (A) and PCSV (Purge control solenoid valve)
hose (B).
|
8. |
Disconnect the throttle body coolant hoses (A).
|
9. |
Remove the oil level gauge (A).
|
10. |
Remove the intake manifold stay (A).
|
11. |
Remove the intake manifold (A) with the gasket (B).
When installing the intake manifold, tighten the bolts and nuts with
pre-torque first, and then tighten the bolts and nuts with specified
torque in the sequence shown.
|
12. |
Install in the reverse order of removal.
|
SRS components and functions
The SRS consists of the following components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side impact air bag modules
4. Curtain air bag modules
5. Retractor ...
ESC OFF Switch Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer the Body - & ...
Seat warmer (if equipped)
The seat warmer is provided to warm the front seats during cold weather.
With the ignition switch in the ON position, push either of the switches to warm
the driver's seat or the front passeng ...