1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
2. |
Check the continuity between the terminal and the body when the fine
wire is pushed. If there is continuity even when the fine wire is pushed,
replace the switch.
|
3. |
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied
through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace
it.
|
Specifications
Front Suspension
Item
Specification
Suspension Type
Macpherson Strut
Shock absorber
Type
H.P.D (High Performance Damper)
C ...
Roof Trim Components
1. Headliner
2. Sunvisor
3. Assist handle
4. Assist handle mounting bracket
5. Room ramp
6. Sunvisor mounting cover
...
Idler Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the idler(A).
Tightenin ...