BSM (Balance Shaft Module) Chain System
1. |
Remove the timing chain.
(Refer to Timing System in this group)
|
2. |
Install a stopper pin (A) after compressing the balance shaft chain
tensioner.
|
3. |
Remove the balance shaft chain tensioner (B).
|
4. |
Remove the balance shaft chain tensioner arm (C).
|
5. |
Remove the balance shaft chain guide (D).
|
6. |
Remove the balance shaft chain (E).
|
7. |
Remove the BSM (Balance Shaft Module) after removing the BSM mounting
bolts.
|
BSM (Balance Shaft Module)
1. |
Remove the under cover.
|
2. |
Remove the RH front wheel.
|
3. |
Drain the engine oil.
|
4. |
Remove the A/C compressor lower mounting bolts (A).
|
5. |
Remove the A/C compressor bracket (A).
|
6. |
Remove the oil pan (A) after removing the bolts.
Insert the blade of SST (09215-3C000) between the ladder frame and oil
pan. Cut off applied sealer and remove the lower oil pan.
|
7. |
Set No.1 cylinder to TDC/compression.
|
8. |
Put a mark on the timing chain (A) corresponding to the timing mark
(B) of the sprocket.
|
9. |
Insert a stopper pin (A) into the hole on the tensioner after compressing
the balance shaft chain tensioner piston.
|
10. |
Remove the BSM mounting bolts.
|
11. |
Remove the BSM (Balance Shaft Module) (A) while taking off the chain
from the sprocket.
|
Evaporator Core Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
...
Operation
Power Tailgate Opening
** - Primary switch signal received by PTGM via CAN bus (sent by IPM)
PTGM Opening procedure:
1.
Opening can be triggered after a signal i ...
Drive Belt Inspection
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  ...